7
PARAMOUNT MODULE ALIGNMENT GUIDE
INSTALLING NOZZLE CAPS
TO FUNCTION PROPERLY IT IS IMPERATIVE THAT THE MODULE BE PLACED IN
CORRECT ORIENTATION TO THE BASE. TO ENSURE THIS IS DONE,
PLEASE FOLLOW THESE INSTRUCTIONS.
1. Look at the top of the Module - Figure 1
2. Locate the Multi port Tube Assembly - Figure
1A
3. Look at the Base - Figure 2
4. One open port is centered between two
plugged ports - Figure 2
5. When installed, the ports centered under the
Multi port Tube Assembly (Figure 1A) on the
Module must be centered over the open ports
in the Base - Figure 2A
Figure 1
2-Port Module
Figure 2
Base
Figure 2A
Ports
Figure 1A
Multi port Tube Assembly
If the Module is placed incorrectly, the returns and nozzles in the pool will fire at the
same time.
Small Nozzle Tool Part #004-552-5452-00
4. Turn cap clockwise until
it snaps into place.
1. Select nozzle size from pool
plan and using the nozzle
tool to twist on caps.
2. Place the nozzle inside
the nozzle tool to hold
it from spinning as you
twist on the cap.
3. Place the cap on the
nozzle. It will go on and
twist one way.