Paramount Fitness ClearO3, Руководство по установке

Страница: 14 / 20

14
Mounting Instructions
1. Turn the power off to the pump.
2. Remove the pressure gauge from the filter.
3. Install the nipple into one end of the brass tee.
4. Install the pressure gauge by threading into
the other end of the brass tee supplied.
5. Install the tubing compression fitting by
threading into the side of the brass tee.
6. Install the tee assembly by threading into the
hole where you removed the pressure gauge
(Fig. 21).
7. Insert one end of the tubing into the compression fitting (Fig. 21).
8. Turn the power on to the pump and check that air is coming from the other end of the tubing.
9. Turn the power off to the pump.
10. Pick a spot on the return pipe downstream of all other devices (heater, chlorinator, pressure cleaner, etc.)
11. Drill a 7/16” hole through the return pipe at the location selected.
12. Install the saddle clamp with the fitting over the hole. Make sure the gasket is in place between the fitting
and the pipe. (Fig. 21)
13. Lay the tubing along the return pipe to the saddle clamp fitting and cut off excess length.
14. Connect the end of the tubing to the compression fitting on the saddle clamp (Fig. 21). The tubing can be
secured to the pipe using cable ties (not included).
Installation of External Safety Air Bleed Kit
Fig. 21
1
2 3
4
FROM
PUMP
FILTER
HEATER
CHLORINATOR
BIOSTAT/
BIOCIDE
RETURN
LINE
NOTE: Ozone production from direct UV light will decline over time. UV bulbs continue to illuminate after they
stop producing an effective level of ozone to clean your pool water. To make sure your pool continues to receive
all the benefits of ozone, Paramount recommends that you replace your bulb every three (3) years or 13,000
operating hours.
BULB REPLACEMENT
Turn off power at main source before making any electrical
connections or servicing the unit. UV light produced by this
unit is harmful to the eyes and may cause blindness! Do not look
directly at a lit bulb!
DANGER