Paramount Fitness BM30ATS, Руководство по установке и эксплуатации

Страница: 10 / 17

8
Cleaning / Maintenance
C
AUTION
:
ALWAYS TURN OFF THE POWER SUPPLY BEFORE CLEANING OR MAINTENANCE
THIS UNIT IS NOT WATER PROOF.
DO NOT USE WATER JET SPRAY TO CLEAN INTERIOR OR EXTERIOR OF THIS UNIT.
Cleaning Guidelines
The mixer should be thoroughly cleaned daily with a clean damp cloth and plastic scraper (metallic
implements are not recommended.
Never use a metal or stiff brush to clean the mixer
.
Never clean the mixer with a water hose or any
fluid pressure.
Bowls and agitators should be removed from the mixer and cleaned in a sink. The bowl guard should
be removed periodically and wiped clean.
Maintenance Guidelines
The Transmission Case and Planetary Mechanism should be inspected weekly for leaks, damage,
etc. Should it become necessary to repack the ball bearings, an authorized service technician or the
manufacturer should be contacted. Use of unproved grease or lubricants may lead to damage and
void the unit’s warranty.
The Bowl Lift Slides (Figure 2) should be lubricated every six months, or more often under heavy
usage.
Disconnect the unit from the power supply before removing the top housing or apron.
The Drip Cup (Figure 2) should be inspected periodically for moisture or lubricant dripping. Remove
the cup and wipe it with a soft cloth.
Any parts found to be damaged, defective or worn out should be replaced immediately.
Fault Finding
Fault Possible Cause Remedy
The mixer does not operate. The mains isolating switch on the
wall, circuit breaker or fuses are
'Off' at the power board.
The mixer electronic timer is set
to ’0’.
Turn 'On'.
Set time setting, or set electronic
timer to '0' to allow manual
operation.
Mixer stops during operation. Mixer overload tripped.
(Ensure that mixer is not being
overloaded - refer to table on
previous page for capacity guide).
Single phase models:
Press reset button at rear of
mixer.
Three phase models:
Call service