Part C
–Wireless Remote Sensor:
C1: Battery compartment
Initial operation:
Open Weather Station battery compartment cover
Insert 2 x AA batteries observing polarity [ “+” and “ –“ marks]
When you insert the batteries, all the icon on the LCD display will briefly light up for 3 seconds, and you will
hear a beep tone, and detect indoor temperature.
The Weather Station will now start to make a connection to the Remote remote sensor. This operation
takes about 3 minutes and is displayed by a flashing reception RF antenna symbol in the “OUT” display area
on the receiver.
This now, replace Wireless Remote Sensor battery compartment cover ,Open Weather Station battery
compartment cover ,Insert 2 x AA batteries observing polarity [ “+” and “–“ marks]
After receiver has created a connection to the remote sensor, it will then b enters the Radio control time
receive mode.
Reception of the Radio signal:
The clock automatically starts the
DCF
signal search after 7 minutes of any restart or changing of new
fresh batteries. The radio mast icon starts to flash.
At 1:00 /2:00 / 3:00 am, the clock automatically carries out the synchronization procedure with the
DCF
signal to correct any deviations to the exact time. If this synchronization attempt is unsuccessful (the radio
mast icon disappears from the display), the system will automatically attempt another synchronization at the
next full one hour. This procedure is repeated automatically up to total 5 times.
To start manual
DCF
signal reception, press "+" and "-" button
at the same time. If no signals received
within 7 minutes, then the
DCF
signal search stops (the radio mast icon disappears) and start again at the
next full one hour.
During RC reception
，
to stop searching radio signal, press and hold
the “-” button more than 2 seconds.
F.Y.I.:
A flashing radio mast icon indicates that the
DCF
signal reception has started
A continuously displayed radio mast icon indicates that the
DCF
signal was received successfully
We recommend a minimum distance of 2.5 meters to all sources of interference, such as televisions or
computer monitors
Radio reception is weaker in rooms with concrete walls (e.g.: in cellars) and in offices. In such extreme
circumstances, place the system close to the window.
During the RC receive mode, only the
“
-
” button function, other button operation have no function, If you
want to carry out other functions of operation, please press and hold
the “
-
” button more than 2 seconds to
exit the RC receiving mode.
