Paradyne iMarc SLV9128, Руководство по установке

Страница: 26 / 36

26
Verifying Connections and Setup
Check the modem, DSX, Ethernet, DTE, and PVC connections, as well as the ISDN
DBM setup if a DBM is installed.
Checking the Modem Connection
Procedure
If Port Use is set to Terminal (dial-in access):
1. Dial the modem’s phone number using a remote asynchronous terminal or PC.
2. Verify that the Main Menu appears.
If Port Use is set to Net Link (SNMP, Telnet, FTP, and trap dial-out):
1. Dial the modem’s phone number using a PC running PPP or SLIP link protocol.
2. From the PC, run an IP Ping test to the modem interface.
If your results using either method are unsuccessful, make sure both ends of the
modem cable are properly seated and secured. Then, verify that the modem was
configured correctly (see
Setting Up the Modem on page 17). Otherwise, refer to the
status information in the iMarc SLV Operations Guide .
Checking the DSX Connection
Procedure
1. Verify that the DSX signal (SIG) LED is green, and that the DSX out-of-frame (OOF)
and alarm (ALM) LEDs are off. If so, the DSX interface is set up correctly and is
operational. If not, make sure both ends of the DSX cable are properly seated.
When ALM is on, contact the service provider.
2. Check Health and Status messages in the left column of the System and Test
Status screen.
Main Menu
→
Status
→
System and Test Status
If any DSX-1 messages appear, refer to the status information in the iMarc SLV
Operations Guide .
Checking the Ethernet Connection
Check Health and Status messages in the left column of the System and Test Status
screen to verify that there are no Ethernet-related Health and Status messages.
Main Menu
→
Status
→
System and Test Status
If the
Ethernet Link Down
message appears, make sure both ends of the Ethernet
cable are properly seated.