98-15304-01
6-Pin
RJ11 Plug
DSL
Cable
Pin #1
Pin #6
12
Local Console Access
When the local console connection is first established, access control to the IDSL
router displays an initial prompt of
Login>
.
"
Procedure
1. At the initial prompt of
Login>
, enter the factory default Login ID of
paradyne
.
2. At the
password>
prompt, enter the factory default Password of
abc123
.
3. At the next prompt for System ID, the factory default is
CUSTOMER>
. Type
show
system
to display hardware/firmware information and Selftest Results.
Refer to the Hotwire DSL Routers User’s Guide for configuration settings and
command line entries.
Increasing the Number of End-User Systems
The Hotwire 6301/6302 IDSL Router can support differing numbers of end-user
systems depending on the functions that are enabled and traffic loading. Typical
configurations will provide support for up to 32, 64, or 256 hosts (end-user systems).
The number of end-user systems can be increased by either using subnets for static
addressing or using Dynamic Host Configuration Protocol (DHCP) for dynamically
assigning addresses. Increasing the number of PCs may require cabling changes.
Refer to Cables & Connectors.
Refer to the Hotwire DSL Routers User’s Guide for configuration settings and
command line entries.
Cables & Connectors
This section is reference information.
Use a CAT3 or better cable for the DSL line.
H
The DSL interface connector uses a 6-pin,
non-keyed modular plug.
RJ11 6-Pin Connector
Pin #
Function
1 & 2
Not used
3
DSL Ring
4
DSL Tip
5 & 6
Not used
