14. System Commands
14-32
August 2002
4200-A2-GB20-00
ne_nblk
RMTSYSLOG: Remote syslog. Enables or disables syslog messages to
a remote daemon. The default is Disabled.
SYSLOGIPADDR: Syslog server IP address. Specifies the IP address
of a remote syslog server if RMTSYSLOG is enabled. Valid values are:
– ddd.ddd.ddd.ddd: IP address (ddd = 0
−
255)
– NONE: No server is specified
SYSLOGPORT: Syslog UDP port. Specifies the destination UDP port
number used to send syslog messages to a remote syslog server if
RMTSYSLOG is enabled (0
−
65535).
SYSLOGSEVTHLD: Syslog severity threshold. Specifies the minimum
severity level of messages logged to the syslog. Valid values are:
– EMERG: Emergency. System is unusable.
– ALERT: Action must be taken immediately (unused).
– CRITICAL: Critical and major alarm conditions.
– ERROR: Minor alarms and autonomous message classification
alarms.
– WARNING: Warning conditions (unused).
– NOTICE: Normal but significant conditions (unused).
– INFO: Informational messages related to operational task status
such as download successful, configuration change notification,
and test start/stop.
SYSLOGRTLMT: Syslog rate limiting. Enables or disables syslog rate
limiting. Valid values are:
– ENABLED: The same syslog message will not be relogged within
a 5-minute period.
– DISABLED: Rate limiting of syslog messages will not be
performed.
SPECMGMT: Spectrum management. Enables or disabled spectrum
management support. When enabled, the maximum transmit speeds
and maximum transmit power are limited to meet local spectrum
management guidelines. Valid values are:
– ENABLED: Spectrum management guidelines are enforced on
the NE.
– DISABLED: Spectrum management guidelines are not enforced
on the NE.
TSTTMOUT: Test timeout. Specifies the amount of time a test will be
allowed to run before automatic termination (0
−
99 minutes, where 0
disables automatic timeout)
Table 14-25. SET-NE-ALL Command Parameters (2 of 2)
SET-NE-ALL:[tid]:[aid_com]:[ctag]:::ne_nblk;
Содержание GranDSLAM 4200
