FrameSaver NP 110 Specifications
2. Plug the Power Pac at the other end of the power cord into an AC outlet.
3. The unit will go through the following power-up sequence:
FrameSaver NP 64+ Power-Up Sequence
If the LED indications are not as described above, refer to Section 5, “Diagnostics” of
the FrameSaver NP 64+ User’s Manual - Installation Guide.
If operation looks normal, unplug the FrameSaver NP before making input/output con-
nections.
If an optional Power Control Unit (PCU) is to be installed with this FrameSaver NP,
refer to the instructions provided with the PCU and install it now.
Proceed to Making Network and Input/Output Connections on page 9 of this guide.
Item
Description
Dimensions
Table Top (with rubber feet):
3.5" H x 10.5" W x 12.0"D.
Wall Mount (with removable wall mounting bracket):
10.5" H x 12.0" W x 3.5" D.
Rack Mount (with removable rack mounting adapter):
5.25" H x 19.0" W ( or 24.0" W ) x 12.0" D.
Weight
As normally packaged including carton and accessories: 8 lbs.
Unit alone (without packaging and accessories): 6 lbs.
Operating
Range
Temperature: 0 to 50 degrees C. operating.
Relative Humidity: 5 to 95% non-condensing.
Altitude: 10,000 ft. max. operating,
50,000 ft. max. non-operating.
Shock and Vibration: As normally encountered during shipping
and handling.
Power
Requirements
AC Input 100 - 240 VAC, 50 - 60 Hz., 5.0A max.
0.5A max. for the unit’s internal power requirements.
4.5 A max. for device (if any) connected to the Switched AC
Output.
Fused - 5A/250V Slow Blow, 5x20mm.
Switched AC Output: max, 250 VAC, 4.5 A.
CAUTION:
FOR CONTINUED PROTECTION AGAINST RISK OF FIRE,
REPLACE FUSE ONLY WITH THE SAME TYPE AND
RATING.
ATTENTION:
POUR NE PAS COMPROMETTRE LA PROTECTION
CONTRE LE RISQUE D’INCENDIE REMPLACER PAR UN
FUSIBLE DE MEMES TYPE ET CARACTERISTIQUE
NOMINALES.
Regulatory
Compliance
UL - 1950, Third Edition and CAN/CSA C22.2 No. 950-95,
Third Edition, FCC Part 15, Class A Digital Device,
Canada’s ICES003, Class A Digital Device, FCC Part 68
Basic FrameSaver NP 64+
FrameSaver NP 64+ with ISDN
POWER LED lights and stays on.
READY LED may flash several times,
then remain OFF during self-test
(approximately 45 seconds).
READY and ISDN READY LEDs
may flash several times, then remain
OFF during self-test (approximately 45
seconds).
READY LED is ON steady after
completion of self-test.
READY and ISDN READY LEDs are
ON steady after completion of self-test.
The DDS ALARM and FR MGMT. LEDs should not be flashing together.
All other LED indications should be ignored at this time.
5
12
