45
Configuring the ATI Graphics Ultra+ Video Card for 14
I
and 17
I
Monitors
There are no preinstallation requirements for this card and there are no user-configurable switches
on the board. You must, however, configure the card via software for use as a full-feature
workstation on the NMS.
To configure the ATI Graphics Ultra+ Video
card, perform the following steps:
1. Insert the GRAPHICS ULTRA+ Disk 1 of 3 diskette into the a: drive and at the C: prompt:
TYPE:
a:install
PRESS:
Enter
2. Using
the
↑↓
keys at the Main menu,
SELECT:
Set Power-Up Configuration
PRESS:
Enter
3. Using
the
↑↓
keys at the Main menu,
SELECT:
Monitor Type
PRESS:
Enter
4. Using
the
↑↓
keys at the pop-up menu,
SELECT:
Custom
PRESS:
Enter
5. Using
the
↑↓
keys at the pop-up menu,
SELECT:
1024 * 768
PRESS:
Enter
6. Ignore the warning message,
PRESS:
Any key (to continue)
7. Using
the
↑↓
keys at the pop-up menu,
SELECT:
x
Where:
x is 60 Hz Non-interlaced for 14-inch monitor and 72 Hz Non-interlaced
for 17-inch monitor
PRESS:
Enter
A display appears with a user-adjustable boundary.
8. Using
the
↑→↓←
keys, adjust the position of the boundary to accommodate your display
size requirements.
PRESS:
Enter
PRESS:
Esc
