SR150-EI14 05/2015
SR150 V2.30
PARADOX.COM
Red
Blue
Clear
Lenses
Amber
SR150 Wireless Siren w/Built-In Strobe Light
Description
The SR150 is a
weatherproof,
stand-alone, fully supervised outdoor wireless
siren with built-in strobe light and wireless transceiver. The SR150 uses 2-way
wireless communication, which provides continuous supervision between the
panel and siren with fast response to alarm signals within four seconds.
With its tough weatherproof construction, the SR150 operates reliably
from -30ºC to 50ºC (-22ºF to 122ºF) when using alkaline batteries or power
supply.
With normal use, the SR150 will function up to 3 years without the need to
replace the batteries (battery life can be extended by using an optional AC or
DC power supply).
This guide describes how to install and configure the SR150 wireless siren.
Included Items
•
1 strobe lens (available in red, blue, amber, or clear)
•
3
D
type alkaline batteries
Required/Optional Items
•
Mounting hardware
•
8-16VAC, or 9-20VDC external power supply (optional)
Compatibility
•
EVOHD v.1.20 or higher
•
EVO192 v3.20 or higher
•
MG/SP series v4.0 (except SP4000)
•
MG6250 v3.0 or higher
•
RTX3 v1.5 or higher/ v5.30 for EVO panels
•
K32LCD v1.3 or higher
•
BabyWare v2.8 or higher/ v2.30 for EVO panels
Features
•
Internal protective plastic cover
•
Built-in transceiver
•
100dB wireless siren
•
Integrated strobe light
•
Weather-resistant design using a PC/ABS enclosure with UV
protection
•
Fast alarm response time (4 seconds)
•
2.5 hour alarm display (strobe flashes every 4 seconds after bell
cut-off )
•
Siren presence supervised by control panel
•
Dual tamper protection for cover removal and removal from wall
•
Assign up to 4 sirens per control panel
•
Firmware upgrade via 307USB
•
Siren test mode
Overview
Figure 1: SR150 Overview
LED Feedback
Figure 2: LED Status Indicators
The following table describes LED Status Indicators.
Number
Overview Description
1
100dB siren
2
Battery pack (3 “D” size alkaline batteries) with gold plated
battery connections or optional 3.6VDC
3
Power supply input (8-16Vac / 9-20VDC)
4
In-field firmware upgrade connector
5
Dual-action tamper switch (detects when cover is removed
and when unit is removed from wall)
6
Internal protective plastic cover
7
Test switch
8
LED status indicators and signal strength (See LED Feedback
below for details)
9
Antenna (can be extended using an RG6 or RG59 coaxial
cable with standard male F connectors. Attach the antenna
using a female/female F adaptor)
10
Strobe lights
LED
Indicator
Description/Status
TX
Sending data
RX
Receiving data
PSSI
Signal strength siren receives from control panel
Flash 4x - strong signal
Flash 3x - good signal
Flash 2x - weak signal
Flash 1x - very weak signal (relocate)
No flash - no signal
Status
Flash once/sec. - processor is on
Flash once/4 sec. - power save mode
1
3
5
6
7
8
9
10
4
2
