18
Reference & Installation Manual
6.0 Panic Alarm Programming
If the panic alarm feature is enabled for the remote control (refer to section 4.3.3 on
page 13), pressing buttons
(refer to Figure 4.2 on page 13) simultaneously
will generate a panic alarm.
6.1 Panic Output Programming (Esprit mode only)
SECTION
[25]
:
OPTIONS
[0]
TO
[4]
When a remote control activates a panic alarm, the MG-RCV3 can be
programmed to activate one of the four on-board PGM outputs. Enable one of
the options from [0] to [4] (refer to Table 6.1 on page 18) by pressing the
corresponding keypad key.
6.2 Panic Lockout Timer (Esprit mode only)
SECTION
[26]
:
OPTIONS
[0]
TO
[4]
When a remote control activates a panic alarm, the MG-RCV3 can be
programmed to ignore any incoming remote control (RF) signals for a specified
time period. Enable one option from [0] to [4] (refer to Table 6.2 on page 19) by
pressing the corresponding keypad key.
How to program the panic outputs.
In step 4 in section 3.2 on page 10:
1. Enter section
[25]
.
2. Enable only one option from
[0]
to
[4]
(refer to Table 6.1 on page 18).
3. Press
[
ENTER
]
.
Table 6.1: Panic Outputs
Key
[0]
ON
= No PGM output on panic alarm
Key
[1]
ON
= Toggle PGM 1 on panic alarm
Key
[2]
ON
= Toggle PGM 2 on panic alarm
Key
[3]
ON
= Toggle PGM 3 on panic alarm (default)
Key
[4]
ON
= Toggle PGM 4 on panic alarm
+
MGRCV3ES_EI01.fm Page 18 Wednesday, May 4, 2005 3:27 PM
