PG748EX-961111-0002
SOFTWARE VERSION 3.00
CONTROL PANEL RESET:
Installer lock must be unlocked.
(Address 058: enter any value other than 147)
Power down reset
(1) Remove battery and AC to power down the unit.
(2) Connect a jumper between "reset jumper" pins.
(3) Connect AC and/or battery.
(4) Wait 3 seconds.
(5) Remove jumper.
Factory default installer and master codes will be reinstated. Values entered at addresses 008-043, 062-126 and 300-523
as well as all user codes, will be erased ([2
ND
] [2
ND
]). Programmed values of all other addresses do not change.
HEXA PROGRAMMING:
All digits from 0 to F are valid. Values are programmed into
memory locations from address 000 to 043 and from address
300 to 523.
1) Press [
ENTER
] + installer code.
2) [
ENTER
] will flash (programming mode).
3) Enter 3 digit memory address.
4) Current value will be displayed on keypad.
5) Enter 2 digit data.
6) Go to step 3 for next address.
To exit programming mode, press [
CLEAR
].
STREAMLINED SECTION PROGRAMMING
Can be used to program sections 00 to 66. (addresses 000 to 043 and 300 to 523)
Press [
ENTER
], installer code, and [7]. ([2
ND
] and [
ENTER
] keys alternately flash.)
Enter a 2-digit section number, followed by 8 digits to program that section (confirmation beep). Data will be saved
automatically and the software advances to the next programming section. To exit programming mode press [
CLEAR
].
INSTALLER CODE:
(reset code 747474)
(addresses 000, 001, 002)
SECTION 00
Full access to programming, except access codes. (addresses 127-299) No access to arming/disarming. Can be used to
modify installer code. Use only numeric keys from [1] to [10]. (key [10] = 0)
PANEL ANSWER OPTIONS:
(address 003)
SECTION 00
First digit disables “Answering Machine Override” (key [2
ND
] or key [1]), or determines period of time between first and
second call (see table below). Second digit determines number of rings required before panel will answer. If [2
ND
][2
ND
]
is entered, panel will not answer. (Default value is [2
ND
] [8].)
- 1 -
Value of
2
ND
digit = 10
( 8 + 2 = 10)
Value of
1
ST
digit = 3
( 2 + 1 = 3)
VALUE
= "3A"
HEXA DISPLAY
No display = SKIP (empty)
No light = 0
10 = [0] = [A]
If key is lit
= 8 = 4 =
2 =
1
If key is lit
= 8 =
4 =
2 =
1
