HSL-32 Hibachi Griddle Operator Manual
Griddle Island Preparation
•
15
Clearances
Your griddle must be installed to ensure sufficient clearance from any combustible materials. The customer
is responsible for compliance with all local codes and product placement.
Surface Clearances
Combustibles Materials:
Ensure your griddle is located at least 16” from any combustible material such as
wood, gyprock, paper and plants. Do not store combustible materials, gasoline or flammable liquids or
vapors anywhere in the vicinity of the griddle. Ensure clearance from the griddle to any combustible
material is never less than 14” from sides and 16” from back. Follow all city and local codes.
Overhead construction:
•
Do not locate the griddle under any unprotected, combustible overhead materials
•
At least 6’ clearance is required between the griddle and overhead construction
•
An exhaust hood is required if the griddle is below unprotected combustible materials, and is highly
recommended for any overhead construction
•
When a vent hood is used, the coverage must be larger than the cooking surface of the griddle, with
a minimum of 1200 CFM air movement
Custom Island Construction
This griddle is for outdoor use only! Do not operate in a building,
garage, or any other enclosed area. Doing so could result in carbon
monoxide buildup which could result in injury or death.
Do not install or operate the griddle in or on a recreational vehicle,
trailer, boat, marine craft, or other moving conveyance.
Paradise Grills makes no warranties or representations as to the safe and proper design, construction,
ventilation, or installation of a custom-built griddle island.
The following planning considerations are provided as general information only. You must consult with a
licensed contractor to ensure safe and proper design, construction, ventilation, and installation in
accordance with all applicable codes.
Because the amount of venting required varies on a case-by-case basis, consult with a licensed contractor
and local codes for adequate ventilation requirements. Keep all enclosure ventilation openings free and
clear from any debris or obstructions.
