WB 2000
22
• Always remove the plug from the socket when not using the device, when replacing the
nozzles or during maintenance of the device
• Do not point the device at the same place for longer periods of time
• Do not hold the device too close to the surface about to be worked on as the
device can overheat
• Pay attention to the direct / indirect workspace as th
e heat can ignite flammable
materials, which are close by but not necessarily in view
• Do not allow the hot parts of the device to touch the cord or other flammable materials
• The device should always be clean, dry and free of grease and oil
• Do not use
the appliance for purposes other than for which it is intended.
This appliance operates at a temperature of 600 degrees without visible signs
of this temperature (no flames), still there is a chance of fire risk. Watch out for
the hot air stream from the mouth piece. This air stream can cause burns.
When operating the appliance
• If you are going to use the tool, vapours and gas can be released during a short time.
This can be harmful for your health. Asthmatics can suffer hindrance of it;
• Before conn
ecting the plug to the mains voltage you have to check if the switch is in
position “0”;
• Keep the mains lead always away from the nozzle of the tool;
• Keep children and animals away from the appliance if you are using it.
• Keep all parts of the body aw
ay from the metal heating head. Do not touch it before it
is cooled down.
• Carry the appliance by the handle when the metal heating head is cooled down.
• Hold the appliance by insulated gripping surfaces only, because the metal heating
head may contact hidden wiring or its own cord.
Immediately switch off the appliance when:
• Plug and/or cable are defective or damaged;
• The switch is defective;
• You smell or see smoke caused by scorched insulation from the appliance.
Electrical safety
When using electric machines always observe the safety regulations applicable in your
country to reduce the risk of fire, electric shock and personal injury. Read the following
safety instructions and also the enclosed safety instructions.
Always check that the power supply corresponds to the voltage on the rating
plate.
Class II machine
–
Double insulation
–
You don’t need any earthed plug
.
Replacing cables or plugs
If the power cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person, in order to avoid a hazard.
Immediately throw away old cables or plugs when they have been replaced by new
ones. It is dangerous to insert the plug of a loose cable in the wall outlet.
