PAPILLON LS5T-52A, Инструкция по эксплуатации

Страница: 15 / 18

Cod. 95452 – LS5T-52A
After this time interval, the oil under pressure will be overheated and the machine could be damaged.
For such extremely hard log, rotate it by
90' to see whether it can be split in a different direction. In
any case, if you are not able to split the log, this means that its hardness exceeds the capacity of
the machine and thus that log should be discarded to protect the log splitter.
Always set logs firmly on the log retaining
plates and work table. Make sure logs will not
twist rock or slip while being split. Do not force
the blade by splitting the log on the upper part.
This will break the blade or damage the
machine.
Break log in the direction of its growing grain. Do not
place log across the log splitter for splitting. It
may be dangerous and may seriously damage the
machine.
Do not attempt to split
2
pieces of logs at the same time. One of them may fly up and hit you.
FREEING A JAMMED LOG
Release both controls.
After the log pusher moves back and
completely stops at its starting position,
insert a wedge wood under the jammed
log.
Start the log splitter to push the wedge
wood to go completely under the
jammed one.
Repeat above procedure with sharper
slope wedge woods until the log is cornpletely freed.
Do not try to knock the jammed log off.
Knocking about will damage the machine or
may launch the log and cause accident.
REPLACING HYDRAULIC OIL
Replace the Hydraulic oil in the log splitter after every 150 hours of use.
Take following steps to replace it. Make sure all moving parts stops and
the log splitter is unplugged.
Unscrew Oil Drain Bolt with Dipstick to remove it.
Turn the log splitter on the Support Leg side over an 4 liters capacity
container to drain the hydraulic oil off.
Turn the log splitter on the the motor side.
Refill fresh hydraulic oil at the volume as per the hydraulic oil capacity of
a particular model indicated in above specifications table.