PAPILLON 95452, Инструкция по эксплуатации

Страница: 13 / 18

Cod. 95452 – LS5T-52A
SET UP AND PREPARATION FOR OPERATION
l. Bolt the Support Leg to the Log Splitter, lift the
log splitter by the handles at both ends and place
it on a 60
-
75cm high, stable, flat and level work
surface.
2. Familiarize yourself with the controls and
features of this log splitter in the illustrations.
l. Log Pusher
2. Work Table
3. Wedge
4. Lift Handle
5. Support Leg
6. Log Retaining Plates
7. Switch
8. Motor
9. Pushbutton Box
10. Wheels (for Minor Moving ONLY).
l l. Hydraulic Control Lever
12. Control Lever Guard
13. Bleed Screw
14. Oil Drain Bolt
W/
Dipstick
15. Max Pressure Limiting Screw
Before operating the log splitter, the Bleed Screw should be loosened by some rotations until
air can go in and out of the oil tank smoothly.
Air flow thru the Bleed Screw hole should be detectable during the log splitter is under
operations.
Before moving the log splitter, make sure the Bleed Screw is tightened to avoid oil leaking from
this point.
FAILED TO LOOSEN THE BLEED SCREW WILL KEEP THE SEALED AIR
IN HYDRAULIC SYSTEM BEING COMPRESSED AFTER BEING
DECOMPRESSED. SUCH CONTINUOUS AIR COMPRESSION AND
DECOMPRESSION WILL BLOWOUT THE SEALS OF THE HYDRAULIC
SYSTEM AND CAUSE PERMANT DAMAGE TO THE LOG SPLITTER
DO NOT ADJUST THE MAX
PRESSURE LIMITING SCREW!
Max pressure was set before the log
splitter ex work and the max pressure
limiting screw is sealed with glue to
ensure the log splitter works under
pressure no more than 5 tons. The
setting was done by qualified
mechanic with professional
instruments.
Unauthorized resetting will cause the
hydraulic pump fail to output enough
splitting pressure or
RESULT IN SEHOUS
INJURY AS WELL AS DAMAGE TO THE
MACHINE.