Paoli RED DEVIL 2.0, Руководство по эксплуатации и техническому обслуживанию

Страница: 5 / 56

ENGLISH
OPERATING AND MAINTENANCE MANUAL
5
TAB. A TIGHTENING TORQUES
Clutch Cover
M5 Screw 7,4 ft-lb - 10 Nm
Motor Cover
M5 Screw 7,4 ft-lb - 10 Nm
L
Always use a wheel gun with the tightening
torque corresponding to the one required by
the application.
L
If you avoid operating at a higher pressure
than the one required you will save energy,
make less noise, and have less wear on the
appliance.
L
In order not to compromise the functionality
of the rotation reverse shaft, do not unscrew
or loosen never the grub screw of the motor
cover (
view figure Fig.2-C ).
L
The standard adjustment of the force necessary
for the translation of the rotation reverse shaft,
and thus the reverse is already performed
by Dino Paoli s.r.l.. A personalized set of this
force is possible, however, for specific needs
of the operator, acting uniformly on the nr.2
(two) rotation reverser grub screws ( view figure
Fig.2-D ). Tightening the grub screws you will
have an increase in the force required, loosening
them you will have its decrease. Ensure that the
individual regulation does not create problems
of accidental reversal of the direction of rotation.
Perform this adjustment always disconnected
the wheel gun from the air supply.
OPERATING INSTRUCTIONS
Original operating instructions -
The original language of these instructions is English.
L
Before the use, always perform a dynamic
adjustment of the supply air pressure ( view
figure Fig.6 ). Adjust the supply air pressure
on the low pressure gauge turning the
adjusting screw of the air pressure regulator
while keeping the trigger pressed.
L
Do not exceed the maximum supply air
pressure of 175 psi (12 bars) (with wheel
gun running).
REGULATION OF THE AIR PRESSURE
Please pay attention to your wheel gun selector
plate type (2 port or 3 port version).
3 port version
L
Clockwise rotation (loosening): Slide “T” to
the right the rotation reverse shaft and push
“P” the trigger ( view figure Fig.3-A and
figure Fig.3-E ).
L
Counter clockwise rotation (tightening):
Slide “T” to the left the rotation reverse
shaft and push “P” the trigger ( view figure
Fig.3-B and figure Fig.3-E ).
2 port version
L
Clockwise rotation (loosening): Slide “T” to
the left the rotation reverse shaft and push
“P” the trigger ( view figure Fig.3-D and
figure Fig.3-F ).
L
Counter clockwise rotation (tightening):
Slide “T” to the right the rotation reverse
shaft and push “P” the trigger ( view figure
Fig.3-C and figure Fig.3-F ).
HANDLING