12
art.nr.bruk-S2-eng, Rev. 2015-01
Panthera
AB reserves the right to make technical changes
ADJUSTMENTS
7) Brakes
Single hand brake (accessory)
(Fig. 18)
This brake is mounted under the seat frame. The brake should be adjusted to go 4 mm into the tyre
when in locked position This is done by loosing the attachment of the brake with cap key no 10 and
allen key 4 mm, and then moving the brake along the seat frame. Adjust to the desired position and
then tighten the attachment.It is important that its adjusted equally on both sides of the frame.
NB! When the air pressure is low, the tyre is worn or changing to another type of tyre the function of
the brake will change. Check the function of the brake regularly .
High brake
(Fig. 19)
The brake should be adjusted to go 3-4 mm into the tyre when in locked position. If a slight adjust-
ment is required this can be done by rotating the locking arm adjustment, so that the brake goes
further in/out on the tyre depending on the direction in which you rotate. If a major adjustment is
needed, loosen the bolt on the inside of the brake using the 5mm socket key. The brake can then be
pushed forward or backwards into the desired position and the clamp is then tightened again.
NB! The bolt on the inside of the clamp (under the seat) should be opened to move the clamp, not the
bolt on the outside of the clamp.
Fig. 18
Fig. 19
