Panthera AB, Gunnebogatan 26, SE-163 53 Spånga, Sweden, 08-761 50 40, www.panthera.se
Tighten the nuts firmly with spanners 23 and
24 mm.
Adjust the rear axle to get the right balance of
the chair.
Fig. 6
Fig. 5
Fig. 7
Loosen nut (7) and screw (6) to make the stop arm
(2) come loose from the nut (8). Tighten nut (8) firmly
with spanner 15 mm on both sides to fix the rear
axle. Place the stop arm (2) back around the nut (8)
and tighten screw (6) and nut (7).
You may need to ream the axle hole with
reamer 12,7 mm. Test with the rearwheel axle
if it runs smothly in the hole.
Mount height adjustable push handles on
the backrest (if not already done). Remove
the black push handle grip.
Fig. 9-12 shows how to adapt the push handles for
the brake handles
.
Ready-made push handles has art.
no. 4250047.
Fig. 8
Fig. 9
Fig. 10
Mount the included push handle extensions on
the push handles. Put the push handle in a jaw
vice and drill a 3 mm hole straight through, 5 mm
from the edge.
Enter the included pin in the 3 mm hole with
a hammer.
Use a sharp object to make a small hole on
the back of the push handle grips. This to
help air to escape when mounting the grips.
Put a small amount of contact adhesive in
each of the grips and mount them on the
push handles.
Fig. 11
Fig. 12
NOTE!
On Bambino you need to shorten the
pin for the ani-tip lock to app.32 mm to make
space for the stop arm (2).
You may use a punch to knock the pin side ways a little
bit to be able to use an angle grinder to shorten the pin.
Must not be shorter than 31.8 mm to secure the function
of the locking of the anti.tip.
Fig. 4
