INTRODUCTION
Congratula ons you have just purchased one of the finest outboard motor li s available today. With proper
installa on and care, this motor li will provide you with years of trouble free use and performance.
Please take a few moments to review the informa on contained in this booklet to familiarize yourself with
the installa on procedures suggested to successfully mount your new motor li . Installa on is easy
par cularly when you know each step ahead of me.
BEFORE
USING YOUR MOTOR LIFT READ THE OPERATING TIPS (PG. 12) FOR PRECAUTIONS WHEN USING
YOUR MOTOR LIFT ON THE WATER AND WHEN TRAILERING YOUR BOAT.
GETTING STARTED
Here is a list of the tools and hardware that you will need:
Tools and Equipment:
1. Electric drill with 1/8, 3/16, and 1/2 inch drill bits
2. Two 3/4 inch wrenches
3. A Phillips head screw driver
4. For heavier motors, a hoist to li the motor while installing the bracket
Hardware and Supplies: (not included)
4 – ½ inch diameter stainless steel Hex Cap Screws of the appropriate length*
4- ½ inch stainless steel Nylon insert nuts
8 – ½ inch stainless steel flat washers
1 – Tube of clear RTV silicon for sealing the transom moun ng holes (recommended)
1 – Tube of dielectric grease for the electrical connec ons (recommended)
2 – Security bolts that match the clamp bracket on your motor (recommended)
For proper bolt length selec on see the informa on on the following page
.
