04
05
42
"
STAGE 1 – CROSS RAILS
Take the following parts
Item 19 x 2 Cross Braces
Item 30 x 8 Corner Brackets
Small Allen Key
Take the following parts
Item 2 x 4 Hex Screws
Flanged M8 x 12mm
Item 8 x 2 Plain Washers M8
Item 15 x 2 Magnets, Flat Retaining
Item 36 x 4 Slide Nuts M8
You should end up with
the Magnets secured as
shown, This section is for
the Tool Holder.
Loosen all Grub Screws
as shown by turning the
Allen Key anti clockwise.
Insert 2 Corner Brackets into
the Cross Brace end ensuring
to insert the longer ends of
the Corner Bracket.
Use the other Cross
Brace as a guide sliding
the Corner Brackets into
the top and tightening
the upright Grub Screws.
Insert the Slide Nuts
as shown opposite.
Screw in the Hex Screw
Flanged M8. These can
be hand tightened ready
for the Push Handle later.
You should end up with
all Corner brackets
secured as shown.
1A
1F
1J
Take the parts opposite.
Insert the Hex Screws through
the Magnets. Then insert the
Slide Nuts into the Cross Brace.
Add Plain Washers M8 to sit
between the Magnet and the
Cross Braces.
1I
1G
1H
1C
1E
1D
1B
Add a Plain
Washers M8
Washer
42
"
