Here is the finished board as seen from the component side. Notice the striped, minus side of the
capacitors is aligned with the white dot on the board.
That’s it! That’s all there is to it, easy wasn’t it.
Now all that is left is to reverse the disassembly procedure to put your STB back together.
Place the board over the plastic stand-offs and press firmly into place.
Replace the two screws on the right side of the board.
Reconnect the ribbon cable, power cable and the two connections to the rear switch.
Replace the cover.
Reconnect all your connections to your TV and the dish.
Plug in the STB, turn on the switch at the back and watch TV.
After doing this capacitor replacement most people have reported that the TV picture is sharper and
clearer that when their receiver was new.
