C/Ku-band Hookup Scheme for
MPEG-2 Digital Receiver
C-band LNB
Ku-band LNB
High
frequency
splitters
DiSEqC
switch
MPEG-2
receiver
Analog or 4DTV receiver
with dish positioner
C-band
LNB IN
Ku-band
LNB IN
Out to
T V
Out to
T V
IF
IN
For a system with C-band and Ku-band LNBs:
1) Use high-frequency splitters to split the incoming C- and Ku-band LNB signals. Be sure to hook the coax from your
analog or 4DTV receiver to the output marked with the diagonal line (indicating passive one-way voltage flow) on
each high-frequency splitter. Connect the coax from each splitter to the correct LNB input on the analog or 4DTV
receiver (Ku-band splitter to Ku-band
L N B I N
and C-band splitter to C-band
L N B I N
).
2) Connect the other output on the high-frequency splitters to the A and B inputs on the DiSEqC switch, which will
combine the C- and Ku-band signals and feed them to the MPEG-2 receiver through the
L N B I N
input.
3) If your television has more than one coaxial or A/V input, connect the MPEG-2 receiver to one of the inputs and
your analog or 4DTV receiver to the other (both receivers will have a connector labeled
O U T TO T V
). If your
television has one input, run a coaxial cable from the
O U T TO T V
connector on the MPEG-2 receiver to the
A N T
I N
input on your analog or 4DTV receiver. Run a coaxial cable from
O U T TO T V
on the analog or 4DTV receiver
to the input on your television.
How do I program my Pansat 2500A MPEG-2 receiver?
•
Press “
Menu
”
• “
Installation
” will appear on the screen, highlighted; press “
OK
”
• “
Antenna Setup
” will appear on the screen, highlighted; press “
OK
”
• Arrow down the satellite list, pressing “
OK
” on each satellite you want to program; check marks will appear next to
all the satellites you have selected.
• Press “
Exit
”
• Arrow down to “
Satellite Scan
”. Press “
OK
” on satellite to scan.
• Allow the 2500A to scan until “
Progress
” is 100%
• Repeat “
Satellite Scan
” on one odd channel and one vertical channel to scan each polarity
• If no channels are collected, you will need to adjust your satellite dish with your analog IRD and try again.
• Channels that are collected will show up in yellow on “
TV Programs
” or “
Radio Programs
”
How do I set up the DiSEqC switch?
•
Select “
Installation
”
• Select “
Antenna Setup
”
• Select “
Satellite
”
• Select “
DiSEqC
” (#1 for Ku-band; #2 for C-band)
1010 North Frontier Drive • Fergus Falls, MN 56537-1023
Form 600-87M-0305
NOTE:
If you have
an analog receiver
with only one LNB
input and you have
a C- and Ku-band
LNB, you will need
to place a C/Ku
Switch between the
LNBs (or the high
frequency splitters)
and the analog
receiver.
www.skyvision.com
- over -
