BA_PH_245-100-300_EN_06-22.docx
41
Lifting off and removing the fence
Increased risk of accidents due to the high weight of the fence! Lifting and placing the fence
should be done by at least two people or with a suitable hoist (e.g. an indoor crane)!
•
Danger of crushing hands and fingers between fence and machine table!
•
Wear protective gloves when lifting or placing the fence.
•
Acute risk of injury to the feet from the fence falling down!
•
Wear safety shoes with steel toecaps.
•
Only loosen (do not remove!) the quick-release levers (
3
) and (
6
).
•
Fold up the two cover plates (
A
) to the left and right of the fence
(see
•
Then remove the two clamping screws (
S
) (unscrew completely).
•
Erst Then the fence can be lifted off and removed.
Due to the heavy weight of the fence, this operation should be carried out by
2 persons or with a suitable hoist.
Lifting off with Swivel-away Device (Option)
Figure 32: Clamping screws
•
Only loosen (do not remove!) the quick-release levers (
3
) and (
6
).
•
Fold up the two cover plates (
A
) on the left and right side of the fence (see
•
Then remove the two clamping screws (
S
). Unscrew them completely.
•
Erst Then the fence can be swivelled away.
•
When using a swivel-away device, follow the instructions in the touchscreen of the control unit.
For further information see section
16.3. The detailed procedure is described in the separately enclosed op-
erating manual
BA_PH_UT300_EN
(refer to chapter “
Fence Positioning
” / section “
Swivel-away Devices
”).
Operating the digital handwheel
The operation of the handwheel is described in detail in section
S
A