BA_PH_690-200_EN_11-22.docx
63
20.5.2
Components & Overview
Figure 73: Super Gehrfix I overview
20.5.3
Calibrate Super Gehrfix II
To calibrate the Super Gehrfix II, it must first be positioned at 90° using the stop bolt (
7
) as shown in the illus-
tration above. Then press the button on the digital display to complete the calibration procedure.
➔
After successful calibration, the value 0.00° appears in the digital display.
20.5.4
Attach Cross-Cut Fence
•
Tighten the clamping lever (
1
) on the cross-cut fence (
L
) to fix the fixture.
20.5.5
Set Length > 1885 mm
•
Loosen flip stop (
A
) with (
S1
), set to 1885 mm using magnifying glass and clamp with (
S1
).
•
Loosen flip stop (
B
) with (
S2
), move to the desired position and clamp with (
S2
).
20.5.6
Set Angle to 90 Degrees
For 90° cuts, the cross-cut fence (
L
) can be used in different positions:
•
Via the fixing points (
F
) on the left or right of the cross slide. To do this, simply release clamping lever (
1
)
lift off the cross-cut fence (
L
) completely and insert it into the desired fixing points (
F
).
•
In the center of the cross slide, using the stop bolt (
7
) for calibration (procedure see section
X
45°
135°
Saw blade thickness = 3.2 mm
Lever below
(hidden view)
F
(4 x)
5
7
Stop bolt below
(hidden view)
3
1
4
L
X
45°
135°
Sägeblattdicke = 3,2 mm
Hebel unterhalb
(Ansicht verdeckt)
F
(4 x)
5
A
S1
S2
B
7
Anschlagbolzen unterhalb
(Ansicht verdeckt)
3
1
4
L
