1. Begin by setting up the tripod base: press down
on the slide yoke pin clip and swing the outer legs out
until they lock in the working position (note the holes
on the bottom of the slide tube).
2A. Place the frame assembly on the tripod base.
2B. Pocket “A” slides OvER angle “B” while angle
“C” slides INSIDE angle “D”.
A
B
D
C
ASSEMBLY
- 4 -
2C. To hold the tripod base in position during this
procedure set the backstop as shown.
2D. When the frame is correctly positioned on the tri-
pod base release the backstop.
3. To move the winch into the working position rotate the
winch forward slightly with your right hand while raising
the brake arm with your left hand.
