Panduit SmartZone EP042, Руководство пользователя

Страница: 64 / 70

SmartZone Gateway EP042 User Manual
- 64 -
Troubleshooting
Resetting the SmartZone Gateway to Factory
Default Settings
To reset the Gateway unit to factory defaults, perform the following steps:
1. Press and release the Reset button on the front of the unit. The Alarm LED will
flash twice (off/on, off/on).
2. Immediately press and hold the Mode button until the alarm LED goes off.
3. Immediately press and release the Reset button.
NOTE : The unit will now restart. The Status LED will start flashing after around 1 minute.
The reset process is complete, and the IP address is set to the default 192.168.0.253.
Problem: The NMS Cannot Poll the SmartZone
Gateway Unit
l
Solution :Make sure the network is properly connected to the Gateway unit.
l
Solution :Make sure the cable is in good condition.
l
Solution :Try pinging the Gateway unit from another computer on the same net-
work segment as the Gateway unit.
l
Solution :Ensure that the NMS IP Address is in the NMS table of the Gateway unit.
l
Solution :Ensure that the community string has been set for the NMS via the Web
Management Interface.