For Technical Support: www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2014
FS067
Page 3 of 4
Secure the sliding tray with #10 washers and
#10-32 hex nuts provided.
Mount the enclosure to the rack using (4) #12-24
screws.
To install the bend radius brackets, slide the bracket
onto tab with the slot facing outside then snap in
place. (FMD SERIES ONLY)
Insert cable through the grommet. Secure the cable
to the strain relief bracket using a cable tie. Strip 1
meter of jacket from the end of the cable. Attach the
strength member of the cable to the #10-32 stud and
#10-32 hex nut. Use the adhesive mount and cable
tie to secure the cable between the#10-32 stud and
the grommet.
1
2
To remove the bend radius
bracket, disengage latch with
a screwdriver.
Slot
