For Technical Support: www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2014
FS067
Page 2 of 4
To engage the cover, slide forward until the cover
slides under the front tabs then secure in place with
#10-32 screw.
Determine which grommet(s) will be used to bring
the cable into the enclosure. Remove the knock-out
at entry location of the fiber tray. Install grommet
following the proper cutting diagram.
Determine where the spools will be located.
Remove the liner from the tape on each spool and
place them inside the enclosure.
Place the strain relief bracket near area where the
cable will enter the enclosure. Fasten with #10-32
hex nut.
Install the hex nut and washer. This will be used to
secure the strength member that comes out of the
cable.
Cut the small circle
for 1" diameter
innerduct
Cut the large circle
for 1-1/2" diameter
innerduct
Cut the straight lines
when not using any
innerduct
DISCARD
DISCARD
