sources.
14
- Remove protective coating from dies. Insert Crimp Die into the ram
of the Parts Guide.
12-
Place Reel Holders onto Arm, apply pressure (compress spring) while tightening.
then the Cutter Die.
15
-Slide the cutter die upwards then tighten securely
with allen wrench (use small end of wrench to tighten)
Equipment Needed:
Tools Needed:
Safety Equipment
CP-871
Metric Allen wrenches (Set)
CA9 Applicator
Dial Calipers
Power Cord and air line
Side cutters
Glasses
Terminals
Operation Manual
Tool Solutions Division - Romeoville, IL (USA)
Tighten screws to secure Arm.
2
- Screw the Support Posts (2) into the side of the press.
Quick Start Guide
Part Number >> CP-871 Press / CA9 Applicator >> Setup, Loading and Operation
4
- Attach Power Cord, Foot Pedal and Tool Feed (back of press)
5
- Insert Air Hose into Air Regulator on Press then connect to air
1
- Loosen screws (2) on Reel Arm and raise the arm high enough to accommodate reel; rotate 90°.
3
-
Place the Parts Guide over the Support Posts (2) slide to fasten, tighten knobs to secure.
interlock and applicator hits stop (B).
8
-
Raise the handle on the side of the press to secure applicator.
13-
Check label for proper die set, initial setting and shut height. Turn dial to adjust to initial setting.
11
-Place reel on Arm w/label facing outwards, tighten back Reel Stop until parts are aligned with the end
6
- Use handle to Raise Safety Guard door until engaged (click sound). Make sure handle is in the
10
- Loosen thumb screw and remove Reel Holders and spring.
9
- Attach air line to inner fitting on press and adapter to applicator.
QS-CA9 Rev: 00 / April, 2012
Page: 1 of 2
down position.
7-
Place the applicator on base of the press, raise ram (A), slide to the right until rams
2
1
4
5
7
9
11
13
Fully
Assembled
CP-871 with
CA9
Applicator
PRESS SET-UP
10
A
B
3
8
6
12
14
15
APPLICATOR INSTALLATION
