© Panduit Corp. 2014
OPERATION MANUAL
CT-2500 and CT-2500/E
Page 10 of
10
ATTENTION:
Do Not place the battery in your pocket or in your toolbox if there are any
conductive materials in it such as coins, keys, tools or other metallic parts.
TERMINATIONS PER BATTERY CHARGE
The estimated number of terminations before the battery will need to be recharged is dependent on
variables such as the terminal size and type being terminated, ambient temperature, and time
lapsed between termination cycles as well as other variables.
BATTERY CHARGER
Read the instructions supplied with the battery charger.
TROUBLESHOOTING
Before You Begin:
1.
Make sure that the battery is charged. Recheck the battery after several minutes to make
sure the battery is holding its charge.
2.
Use a
nonflammable
contact cleaner or pencil eraser to clean the electrical contacts on the
battery and crimping tool.
3.
Reinstall the battery and check the tool again.
Problem
Probable Cause
Probable Remedy
Tool is inoperative.
Dirt, contaminants, etc., in ram
area of tool.
Clean tool.
Crimping tool battery contacts
damager.
Reform contacts.
Tool components worn or
damaged.
Return tool to
Panduit
Tool Division.
Dies stop during operation.
Oil level is low.
Return tool to
Panduit
Tool Division.
Air in hydraulic system.
Pull trigger and hold retract button
simultaneously. Hold for
approximately 10 seconds.
Tool loses oil.
Damaged internal seal.
Return tool to
Panduit
Tool Division.
DISCONTINUATION OF USE / DISPOSAL
•
The battery cartridge must be specially disposed of according environmental Battery
Guidelines.
•
For the disposal of the remaining parts, please reference environmental guidelines.
•
Because of possible environmental damage, we recommend disposal of the tool by
professional companies.
ATTENTION:
Do not dispose of the unit in your residential or commercial
waste, as it would be hazardous to the environment.
