Note: If wire size changes, tool will need to be readjusted. Follow instructions 3 - 5.
CT-1000 Crimp Setting Reference Chart
With cover open, feed end of ferrule strip
under plastic guides into handle with
insulation facing operator.
Close the cover. If the end of the ferrule strip
is longer than the handle (as shown above),
fold over and close cover.
Tool is now loaded and ready
for crimping.
Insert stripped wire into ferrule
positioned in die pocket.
Push and hold wire into ferrule until orange
adjustment dial on other side of tool moves
outward (as shown above). While maintaining
pressure on the wire close tool handle.
Release handles and remove crimped wire.
The tool will automatically feed a new ferrule
into position for the next crimp.
4. Load Ferrules:
Ensure that first ferrule is seated into the die
pocket as shown above.
5. Crimp Ferrules:
Plastic Guides
Slide ferrules until strip comes to a
stop under the die pocket.
Part
Number
Tool Crimp
Setting
Part
Number
Tool Crimp
Setting
Din End Sleeves
End Sleeves
FSD75-8-DSL10
0.5 – 0.75
FS75-8-DSL3
0.5 – 0.75
FSD76-8-DSL8
0.5 – 0.75
FS76-8-DSL10
0.5 – 0.75
FSD77-8-DSL2
1.0 – 1.5
FS76-8-DSL7
0.5 – 0.75
FSD78-8-DSL0
1.0 – 1.5
FS77-8-DSL4
1.0 – 1.5
FSD80-8-DSL6
2.5
FS78-8-DSL2
1.0 – 1.5
FS80-8-DSL8
2.5
After
Before
