background image

 
 
 

 

 

 

 

 

 
 
 
 

Tool Overview 

PANDUIT

 continuously molded ferrules and crimping tools deliver speed and 

reliability for medium volume terminations. The CT-1000 is a multi-use .54 lbs. 
controlled cycle tool that crimps ferrules, and cuts and strips wire. 
 
•  Innovative rapid load design significantly reduces installation time 

 
 
 
 

 

 

 

 

 
 
 
 
 

•  Adjustable die setting allows termination of all continuously molded strip-fed 

ferrules  

•  Designed for use with continuously molded ferrules in strips of 50 
 

1. Cut Wire: 

Insert wire into cutting guide and close 

handles to cut wire. 

Note: Tool intended for use with soft coated, multi-stranded copper 

wire and strip ferrules with polypropylene insulating collars  
from 0.5 - 2.5 mm

2

 

 
 
 

2. Strip Wire:  

Insert wire until it hits stop and close 

handles to strip wire. 

 
 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Adjust orange wire stop to strip length 

specified on the ferrule-package label 

you are using. See sample of package 

label below. 

Release handles and remove  

stripped wire. 

Adjustment screw should be used to set 
strip blade depth. If insulation is not being 
stripped turn adjustment screw clockwise 
¼ turn increments until the desired wire 
strip is achieved. If blade is cutting into 
insulation too deep turn adjustment screw 
counterclockwise ¼ turn increments until 
the desired wire strip is achieved. 

 

13/32

Open tool door as shown above and 

adjust crimp force setting. 

Press in and rotate adjustment dial, until desired 

die setting is reached. Adjustment dial will 

automatically click into place when setting is 

reached. Adjust slide control on cover so that 

the two settings match. These two settings must 

match to crimp correctly. 

3. Adjust Crimp Force Setting: 

With door open, make dial and slide 

adjustments to match specific setting noted 

on package label.  

Adjusting Strip Blade Depth 

 

Отзывы: