PANDUIT
DPoE Power System User’s Guide
Issue 1.0
Part Number: PN380
CAUTION:
ALWAYS FOLLOW NEC GUIDELINES AND YOUR LOCAL COMPANY
PRACTICES WHEN SELECTING DC WIRING AND PROTECTION.
Table 5: Minimum Recommended DC AWG for 90° C Cabling for Unprotected Outputs
shows
recommended wire sizes based on ampacity. The maximum current rating for the chassis is 100 A
.
Re
ct
ifi
e
rs
Single hole bulk
battery connections
(¼" studs)
14 GMT Fuse
Connections
14
1
2
Figure 2: DC Wire Diagram
Each chassis is equipped with 14 GMT style fuse connections and an unfused bulk DC connection
located on the rear of the chassis
.
The GMT fused connections are made on “lugless” terminal blocks
with compression screws.
The bulk DC connection may be used as a battery input or as an unfused bulk output. The connections
require a terminal lug (1/4” single hole lug with a max tongue width of 0.63” or less). Size wires based on
the total rectifier capacity and choose conductor size according to
Table 5: Minimum Recommended DC
AWG for 90° C Cabling for Unprotected Outputs
.
Connecting to a DPoE Power Patch Panel
Each DPoE Power Patch Panel is shipped with a keyed power connector harness and two butt splices
(
PANDUIT
part number BSV14X) for use in connecting the panel to the power source. The butt splices
included with the DPoE Power Patch Panel will support 14 - 16 AWG solid or stranded wire.
WARNING:
Connect each DPoE Power Patch Panel to the rear of the DPoE Power
System using one of the 14 GMT-fused outputs per panel.
DO NOT WIRE MULTIPLE PANELS TO A SINGLE OUTPUT ON THE
DPoE POWER SYSTEM.
5
