Panduit Atlona OmniStream 121, Руководство по установке

Страница: 5 / 12

Installation Guide
AT-OMNI-121
5
TM
O
MNI
S
TREAM
LINK PWR
AT-OMNI-121
ETHERNET RS-232
AUDIO
OUT
IN
L R
DC 48V
RX TX
1
HDMI OUT
PWR indicator
1. Connect an Ethernet cable from the ETHERNET port on the decoder to a PoE-capable
switch on the Local Area Network (LAN). Note that if a PoE-capable switch is not available,
the 48V DC power supply (sold separately) must be connected to the decoder.
2. Connect an HDMI cable from the UHD/HD display to the HDMI OUT port on the decoder.
3. If using RS-232, connect the included 6-pin captive screw connector to the RS-232 port on
the decoder.
4. The PWR indicator, on the front panel, display the power status of the decoder. When the
decoder is powered, using either PoE or the optional 48V DC power supply (not included),
the LED initially turns red. After a few moments it will turn amber, and finally green.
Installation
The AT-OMNI-121 is powered by PoE (Power over Ethernet), when connected to a PoE-capable
switch. If a PoE-switch is not used, then the optional 48 V power supply (Atlona part no. AT-PS-
48083-C) can be purchased, separately. Insert the positive and negative leads, from the power
supply, into the terminals of the 2-pin captive screw connector block, as shown. The orange
2-pin captive screw connector block is included with the OmniStream power supply package.
Power Supply (optional)
AT-OMNI-121
ETHERNET
RS-232
AUDIO
OUT
IN
L
R
DC 48V
RX
TX
1
HDMI OUT
IMPORTANT : The external power supply must be connected to the decoder
when embedding and de-embedding audio using the AUDIO IN and/or AUDIO
OUT ports.
POS
Whit
e
Black
NEG