Panduit ATLONA AT-UHD-SW-510W-KIT, Руководство по установке

Страница: 4 / 16

4
Installation Guide
AT-UHD-SW-510W
The AT-UHD-SW-510W provides an RS-232 port which allows communication between an
automation system and an RS-232 device. This step is optional.
1. Use wire strippers to remove a portion of the cable jacket.
2. Remove at least 3/16” (5 mm) from the insulation of the RX, TX, and GND wires.
3. Insert the TX, RX, and GND wires into correct terminal using one of the included 3-pin
captive screw connectors.
NOTE: Typical DB9 connectors use pin 2 for TX, pin 3 for RX, and pin 5 for ground.
On some devices functions of pins 2 and 3 are reversed.
RS-232
GND
RX
TX
The AT-UHD-SW-510W provides the ability to output two-channel balanced analog audio on the
AUDIO OUT port, using the included 5-pin captive screw connector. This step is optional.
Use wire strippers to remove enough insulation to allow each wire to be securely fastened
to each terminal of the captive screw connector block and connect the wires as shown.
Unbalanced audio is not supported.
Audio
Balanced XLR audio
2 1
3
2 1
3
GND GND
-
+
Rear View
Rear View
-
+