Panduit ATLONA AT-HDR-CAT-4EDLA, Руководство пользователя

Страница: 10 / 45

AT-UHD-CAT-4ED 10
Installation
IP Configuration
The AT-UHD-CAT-4ED is shipped with DHCP enabled. Once connected to a network, the DHCP server (if available),
will automatically assign an IP address to the unit. Use an IP scanner, along with the MAC address on the back of
the unit, to identify both the unit and its IP address on the network. If a static IP address is desired, the unit can be
switched to static IP mode. Use one of the following procedures to switch between DHCP and static IP mode.
The default static IP address of the AT-UHD-CAT-4ED is 192.168.1.254 .
If the AT-UHD-CAT-4ED is unable to detect a DHCP server within 15 seconds, then the unit will set all IP settings to
zero.
IMPORTANT: If the AT-UHD-CAT-4ED is receiving a DHCP IP address, and the IP mode is changed
to static, then Telnet and web server communication will be lost.
1. Make sure the AT-UHD-CAT-4ED is powered.
2. Connect an Ethernet cable between the LAN port of the AT-UHD-CAT-4ED and the Local Area Network (LAN).
3. Press and hold the POWER button for approximately 15 seconds. Release the POWER button once the LOCK
LED indicator begins to flash. The number of flashes will indicate the currently selected IP mode.
Setting the IP Mode
TX TX RX RX
4 3 2
4 3 2
1
1
RS-232
MASTER
IN OUT
LAN
HDMI HDBaseT OUT DC 48V
IR FW
TX TX RX RX
RS-232 IR
TX TX RX RX
RS-232 IR
TX TX RX RX
RS-232 IR
TX TX RX RX
RS-232 IR
4 3 2 1 OUT IN
HDMI HDBaseT LOCK
EDID POWER
AT-UHD-CAT-4ED
INT LEARN
Use the
IPStatic
and
IPDHCP
commands to switch between DHCP and IP mode through RS-232 or Telnet. Refer to
API documentation for more information. All commands and their arguments are case-sensitive.
• Setting static IP mode
1. Connect to the AT-UHD-CAT-4ED using RS-232 or Telnet.
2. At the command line, execute the
IPDHCP
command using the off argument, as shown.
IPDHCP off
Setting the IP Address Using Commands
IMPORTANT: Note that when switching between DHCP and static modes, within a Telnet session,
the connection will be terminated once the IPDHCP command is executed.
POWER button flashes Description
Two Static IP mode IP address: 192.168.1.254
Netmask: 255.255.0.0
Gateway: 192.168.1.1
Four DHCP mode
LOCK LED indicator
POWER button