Pandora Light, Руководство пользователя

Страница: 41 / 52

41
User manual
Level 1 Recording remote controls (D-011)
Level 2 Changing the factory preset of the “Service PIN-code”
Level 3 Recording the idle speed to the system memory
Level 4 Resetting to factory settings
Level 11 Programming and configuring the ”Immobilizer code”
Level 12 Fuel level calibration
Level 17 Programming bypass of original immobilizer
Level 1 – Recording remote controls
Prepare to record all remote controls (you can record up to 4 remote controls), install batteries in the
remote controls. If the main LCD remote control is off, switch it on in accordance with its manual.
Enter programming menu and then press the VALET button once. The LED indicator will light
green and the system will enter the remote controls recording mode. Remote controls are recorded
(paired) one by one, in any order and without time limit. All previously recorded remote controls will
be removed when you overwrite new remote controls or record old remote controls again.
Recording remote controls:
Press three buttons simultaneously and hold them for 1 second (until a short beep
from the main remote control or until LED fading of an additional remote), then release the buttons.
If recording was successful, the LCD remote will emit 2 short beeps and the base unit will emit 1 beep,
after that you can move to recording the next remote control.
Saving changes:
To finish recording, press the VALET button once. The series of red and green flashes of the status
LED indicator will confirm saving.
Level 2 – Changing the factory preset of the “Service PIN-code”
Prepare a new value of the “Service PIN-code”, it should consist of 4 digits (from 1 to 9). Write down
or remember the new PIN-code. Enter programming menu and then press VALET button twice. The
system will enter «Changing Service PIN-code» mode and the status LED indicator will turn off.
Changing the “Service PIN-code”:
• Enter the first digit of the code using the VALET button. Press the button a number of times,
equals to the first digit. Pauses between presses should not exceed 1 second, every pressing will
confirm with an orange LED indicator flash. Pause for more than 1 second and a red LED indicator
flash confirms the input of the first digit. Then you can enter the next digit;