Pandora DXL-1700L, Руководство пользователя

Страница: 15 / 23

29 28
User manual Pandora DXL-1700L service-security system
Entering the programming menu using VALET button
Level 1 Recording remotes and radio tags into the system’s memory
Level 2 Changing the factory preset service PIN-code
Level 3 Recording the idle speed to the system’s memory
Level 4 Resetting to factory settings
Level 5 Programming RHM engine compartment module
Level 6, 7 Programming radio relays 1 and 2
Level 8 Recording GPS/GLONASS receiver Pandora NAV-035
Level 9 Recording of Pandora RW smart watch
Level 10 Configuring system settings via the wireless interface 2,4 GHz
Level 11 Programming validator code of immobilizer (Pin to Drive)
Level 12 Setting and updating GPS/GLONASS receiver NAV-035
Level 13, 14 Reserved
Level 15 Emergency disabling of immobilizer
Level 16 Reserved
Level 17 Setting up keyless bypass of built-in immobilizer
Level 18 Programming DMS-100 sensor
Changing core settings using VALET button
Level 1 Recording remotes into the system’s memory
Enter the first level of programming. Remotes are recorded (paired) one by one. The pause
between recording of remotes and radio tags should not exceed 20 seconds.
To pair the radio tag, press button on the tag and hold it for 3 seconds. If the recording was
successful, the base unit will emit 1 beep, after that you can move to recording the next tag.
To pair the remote, press three buttons simultaneously (on the remote) and hold them for 1
second (until a short beep for the LCD remote), then release the buttons.
To finish the recording of the remote units into the system, VALET button should be pressed again,
the status LED will produce series of red flashes; then switch on and off the ignition to leave the
programming mode.
WARNING!
IF THE CONTROL OVER SIREN IS CARRIED OUT USING RHM ENGINE COMPART-
MENT MODULE, SIREN SOUND SIGNALS WILL NOT BE EMITTED DURING RADIO
TAGS RECORDING!
Level 2 Changing the factory preset service PIN-code
• Indicator LED is not lit. Press VALET button the number of times equal to the first digit of the
new security code. Each pressing of VALET button is followed by red flash of the indicator. The interval
between presses should not exceed 1 second.
• The input will be confirmed with red flash of indicator.
• Enter the other numbers in the same manner.
• The input of the fourth number will be confirmed by series of red and green LED indicator flashes.
• Enter all four numbers again.
• If you were able to correctly enter code twice, the indicator will produce series of red flashes and
a new PIN-code will be recorded, the system will return to the programming mode.
• In case of the incorrect code input the indicator will be lit red and the system will return to a
programming mode.
After the input is complete, the indicator fades, the system awaits a new programming level input.
Level 3 Recording the idle speed to the system’s memory
At this programming level the idle turns speed of the engine is recorded (into non-volatile
memory). Upon entering this level you need to switch the ignition on and start the engine (it should
be warmed-up and the idle speed should match a normal rate for the heated engine). Wait until the
stable idle speed is reached (it takes about 30 seconds). Then press VALET button once.
Successful recording will be confirmed with 1 sound siren signal and with 3 signals in case of
unsuccessful recording.