Pandora DXL 1100L, Руководство пользователя

Страница: 22 / 25

43 42
USER MANUAL PANDORA DXL 1100L SERVICE-SECURITY
S Y S T E M C O N F I G U R A T I O N A N D P R O G R A M M I N G
If the recording was successful, LCD remote will emit 2 short beeps and the base unit
will emit 1 beep, after that you can move to recording the next remote.
Saving changes:
To finish the registration of the radio tags into the system, VALET button should be
pressed once again, the series of red and green flashes of status
LED
indicator will
confirm the saving.
Level 2 – Changing the factory preset service PIN-code
Prepare new value of the «Service PIN-code», it should consist of 4 digits (from 1
to 9). Write down or remember the new PIN-code. Enter programming menu and
then press
VALET
button twice. The system will enter «Changing Service PIN-code»
mode and the status LED indicator will turn off.
Changing «Service PIN-code»:
• Enter the first digit of the code using
VALET
button. Press the button a number of
times, equal to the first digit. Pauses between presses should not exceed 1 second,
every pressing will confirm with orange LED indicator flash. Pause for more than
1 second and red
LED
indicator confirm the input of the first digit. Then you can
enter the next digit.
• Enter the other digits of the new «Service PIN-code» in the same manner. The input
of the fourth number will be confirmed by series of red and green
LED
indicator
flashes. The system will wait for PIN-code re-entering
• Enter all four digits again;
• If you were able to correctly enter new «Service PIN-code» twice, the indicator will
produce series of red and green flashes new PIN-code will be recorded, the system
will return to the programming mode. In case of the incorrect code input the
indicator will be lit red and the system will return to the programming mode and
will wait for input of a new programming level.
Level 3 – Recording idle speed
To timely turn off the starter during automatic or remote engine start
via analog tachometer input, it is necessary to record the engine idle speed.
S Y S T E M C O N F I G U R A T I O N A N D P R O G R A M M I N G
To record idle speed to the non-volatile system’s memory, enter the programming
menu. Press
VALET
button three times. Switch on the ignition and start the engine
after entering this level of programming (the engine should be warmed-up, idle speed
should match the stable idle speed of the warmed-up engine). The system will confirm
the presence of the idle speed status with green flashes of the
LED
status indicator.
Wait until the stable idle speed will be reached and save the changes
Saving changes:
Press
VALET
button once to save idle speed. Successful recording of the idle speed
will be confirmed with one sound signal of the siren. The series of sound signals will
indicate an unsuccessful recording. The system will exit programming menu and
reboot after saving idle speed.
Level 4 – Resetting to factory settings
The procedure recovers the system’s factory settings without deleting
previously registered devices (tags, mobile device, relays, etc.), that was
previously stored in the non-volatile memory. To reset the factory settings enter
the programming mode and press
VALET
button four times. Press and hold
VALET
button for more than 4 seconds until siren sound, then release the button. The system
will confirm the resetting to the factory settings with a long red flash of the LED
indicator. After that the system will return to the programming mode.