9
8
User manual
Pandora DXL-0100L/0101L service-security system
Replacing immobilizer tag battery
Carefully open the cover of the tag’s battery compartment. Extract discharged battery and insert
a new one keeping in mind the correct polarity. Replacing a battery will not cause a loss of tag code
information, as authorization data is stored in the non-volatile memory of the MCU.
Carefully close the cover of the tag’s battery compartment. All elements of construction should be
rigidly locked in places. If it is so, the tag can be operated as usually.
Immobilizer code using original car controls
Code immobilizer is a function that allows disarming and controlling timer channels using
original car controls (button, lever or pedal). To enter immobilizer code, programmed button (lever,
pedal) should be pressed a number of times equal the digit of the code. Pauses between presses
should not exceed 1 second. Pauses more than 1 second will be interpreted as the start of next digit
input. Immobilizer code can consist max of 4 digits from 1 to 9.
After entering a correct immobilizer code, depending on the settings, either the engine blocking
will be lifted or a programmed timer channel will be activated.
Control over system in case of emergency
Emergency disarming/switching off immobilizer using VALET button
In case you cannot disarm the system using a remote, owner’s individual PIN-code can be used.
Individual PIN-code is written on the owner’s plastic card under protective layer. Erase the protective
layer and use VALET button to input PIN-code.
1. Using VALET button, input the first digit of the code (press the button a number of times, equal
to the first digit; pauses between presses should not exceed 1 second). The system will confirm with
red LED indicator flash.
2. Similarly input the second, third and fourth digit. Every input will be confirmed with red LED
flash.
3. The system will confirm correct PIN-code with red and green flashes of LED indicator. If the input
was incorrect, it will be indicated with long red flash. New input can be attempted after 5 seconds.
If immobilizer/Antihijack mode is activated:
4. Using VALET button, input PIN-code. Factory preset PIN-code is 1-1-1-1 (4 presses with pauses
for 2 seconds).
5. The system will confirm correct PIN-code with red and green flashes of LED indicator and will
enter programming mode. New input can be attempted after 5 seconds.
6. To switch off immobilizer/Antihijack function, press VALET service button 15 times (pauses
between presses should not exceed 1 second). The LED will be lit green.
7. Input individual PIN-code similar to emergency disarm. The system will confirm correct PIN-
code with 2 short signals of the siren and with red flash of LED.
8. To activate immobilizer/Antihijack function, enter level 15, the system will confirm it with red
flash of LED. Press VALET button once, the system will confirm it with green flash of LED and with 1
short signal of the siren.
For emergency arming when the engine is stopped, press and hold VALET button for 3 seconds.
The system will be armed in 30 seconds.
While there is a countdown, the LED will be lit red.
WARNING!
MAKE SURE THAT PROTECTIVE LAYER ON THE OWNER’S PLASTIC CARD IS IN-
TACT AFTER THE INSTALLATION OF THE SYSTEM. PLASTIC CARD HOLDS INDI-
VIDUAL PIN-CODE.
