21
20
User manual
Pandora DXL-0100L/0101L service-security system
ADDITIONAL DEVICES
Blocking radio relay
For Pandora DXL-0100L/0101L optionally blocking RR-100 radio relay is available. Blocking radio
relay with built-in accelerometer should be placed in the engine compartment. Herewith zone of
built-in aerial 2,4 GHz should not be shielded.
Provide a rigid fastening to the car body or to the fixed wirings. It is forbidden to hide the module
in wiring. Radio relay power connects either from the ignition or from a constant power wire. Radio
relay is normally closed, blocking is carried out only on unauthorized movement.
WARNING!
DO NOT PLACE RADIO RELAYS DIRECTLY ON ENGINE!
RR-100 Radio relay connection
Wire 1 (Black) should be connected to the
car body in a grounding spot or to a reliable
conductor, connected to car body or to any
grounded device. The wire should be connected
FIRST during installation.
Wire 3 (Black) is used to program radio relay.
Wire 4 (Black) should be connected to
reliable conductor with constant voltage of 12V
or to any wire, which has constant voltage of 12V
(it depends on the system settings) when engine is running and this voltage does not disappear when
driving.
Wire 2 (Black) and 5 (Black) connects to the circuit being blocked. Switching current should be
no more than 10A long-term and 20A for up to 1 minute (if switching circuits are without inductive
component in the load). Contacts of blocking relay are connected to blocking wires as normally
closed (N.C.).
2
5
4
1
+12V
To the circuit being
blocked (20А)
Programming
3
Programming of radio relay
Radio relay can be programmed on level 6 and 7. Level 5 is used to program engine compartment
module RHM-02.
1. Connect wire 1 of radio relay to the grounding spot.
2. Select desired level of the programming menu 6, 7 to program radio relay 1, 2 respectively.
3. Apply power (12V) to the contacts 3 and 4 of radio relay. The siren will confirm recording of radio
relay to the system’s memory with 1 beep.
After successful recording of radio relay switch off and insulate contact 3, connect contact 4 to
the constant power 12V or to any wire, which has constant voltage of 12V when engine is running.
Radio module of engine compartment RHM-02
This module is designed to simplify the system installation and wiring in the engine compartment,
it allows to control additional devices (siren, tachometer, engine blocking, motion sensor and etc.) via
2,4 GHz radio channel.
Engine compartment module RHM-02 is installed discreetly in the engine compartment on the
vehicles with 12V on-board voltage.
WARNING!
DO NOT INSTALL THE MODULE NEAR THE EXHAUST MANIFOLD, AS WELL AS IN
PLACES WITH HIGH HUMIDITY!
