Pandora 397O, Руководство пользователя, Страница: 26 / 31

51
50
User manual Car service and security system Pandora DXL 397O
Control over system in case of emergency, entering individual pin code
In case you cannot disarm the system using a remote, phone or online service, owner's individual
PIN code can be used. Individual PIN code is written on the owner's plastic card under protective layer.
Erase theprotective layer and use VALET button to input the PIN code.
1. Using VALET button, input the first digit of the code (press the button a number of times, equal
to the first digit; pauses between presses should not exceed 1 seconds).
The system will confirm with red LED indicator flash.
2. Similarly input second, third and fourth digit. Every input will be confirmed with red LED flash.
3. The system will confirm correst PIN with red and green flashes of LED indicator.
If the input was incorrect, it will be indicated with long red flash. New input can be attempted
after 5 seconds.
4. If the system was armed, after entering the correct PIN code it will be disarmed.
If the system is disarmed and the engine is stopped, after entering PIN the system will enter
programming mode.
ATTENTION! MAKE SURE THAT PROTECTIVE LAYER ON THE OWNER'S PLASTIC
CARD IS INTACT AFTER THE INSTALLATION OF THE SYSTEM. PLASTIC CARD HOLDS
INDIVIDUAL PIN CODE AND ONLINE SERVICE ACCESS INFORMATION.
For emergency arming when the engine is stopped, press and hold VALET button for 3 seconds.
The system will confirm with buzzer signal and will be armed in 30 seconds.
While there is a countdown, the LED will be lit red.
Any problem can be solved
Problem Solution
When pressing button 1 on the
LCD remote all icons lit, when
pressing button 2 the numeric
indicator will lit.
The remote is switched off, it needs to be switched on.
Press and hold button 3 (F) for 3 seconds.
LCD remote have stopped playing
ringtones.
Low battery power. Please, replace the battery (page 33).
Cannot disarm the system using a
remote. Use additional remote or disarm using a phone command
(0*). Contact the car service that was installing the system.
LCD remote is vibrating constantly. Low battery power. Please, replace the battery (page 33).
One minute after the ignition was
switched off, "signal lost" ringtone
plays and LED indicator starts
flashing red.
The system reminds you that it is disarmed. Please, arm the
system.
The alarm constantly goes off by the
sensor data. The sensitivity is too high. Lower sensor sensitivity
(page 26).
System does not send text
notifications.
1. Text message service center number is incorrect.
The system determines it automatically. However, it should
be changed if changing mobile operator of the system.
Contact the car service that was installing the system.
2. Text messaging is blocked by the mobile operator. Contact
your system's mobile operator.