PANCONTROL PAN 600AD+, Руководство пользователя

Страница: 37 / 194

EN 13
AC Voltage measurement
(Note Fig. 3)
1.
Switch on the device with the rotary switch.
2. Attach the pin-plug of the black test lead to the COM-jack and the
pin-plug of the red test lead to the VΩ-jack.
3. Touch the measuring points with the probe tips.
4. When measuring alternating voltage/alternating current, the frequency is
displayed in the secondary display.
5. Once the reading stabilizes, read the value.
Resistance measurement
(Note Fig. 4)
Before making any measurements, make sure the circuit is disconnected from
any power source and all capacitors are properly discharged!
1. Switch on the device with the rotary switch.
2. Attach the pin-plug of the black test lead to the COM-jack and the
pin-plug of the red test lead to the VΩ-jack.
3. Touch the measuring points with the probe tips.
4. Once the reading stabilizes, read the value.
5. If the resistance is less than about 50 Ω, you hear an audible signal. If the
circuit is open, (>10 MΩ) the display shows “- - - -”.
AC current- (or DC current-) and AC Voltage measurement at the
same time
(Note Fig. 5)
1. Switch on the device with the rotary switch.
2. Press the lever to open the induction jaw.
3. Place the wire in the center of the pliers opening as far as possible and
close the measuring pliers again.
If the measured current is >0.2 A (AC) or >0.3 A (DC), the side display
indicates the measured value (A).
4. Attach the pin-plug of the black test lead to the COM-jack and the
pin-plug of the red test lead to the VΩ-jack.