Panasonic YD-630AT, Руководство по эксплуатации

Страница: 9 / 19

6
Notice:

Please unpack and take off the plastic sheet before using.

Make sure that turn off the switch box before connect the cables.
 Attach a switch with fuse of specified capacity or no-fuse breaker (or leakage breaker) to
the switch box for each welding source.

Use the cable which is more than 16mm
2
if it is more than 10m.

If use the dynamo, then its facility is more thrice than that of power source.
 Reference [ relations between output current and output cable]
Table 4.2
Remark:
The length of welding cable=the length of electrode the length of base metal cable
（
2
）
Grounding
 Keep well grounding, would prevent form electric shock and misaction of equipment
caused by high-frequency electric wave generated by power source controller.
 Check the grounding cable and grounding terminal elaborately, refering to the
inspection points mentioned in DAILY INSPECTION. Make sure reconnect the cable
after turning off the switch box.
（
3
）
Equipment and Material Necessary for Welding
Please prepare these equipment and material before welding as the following:

Electrode holder and base metal cable (self-prepared, according to the table 4.2)
（
4
）
Installation and place
The following conditions should be met for proper operation of the machine.

Indoors free from moisture, dust or dirt.

In a place not exposed to direct sunlight or rainfall.

In a place where ambient temperature is between -10
～
40℃

In a place 20cm or more apart from the wall.

In a place where the welder will not subject to any abnormal vibration or impact.

In a place free from vaporous oil or harmful corrosive gas

When installing two or more units, they should be separated 30cm or more from each
other.
200 300 400 500 630
35 259 147
― ― ―
50 356 202 125
― ―
70
―
286 177 112
―
95
― ―
242 153 48
Output
current (A)
Cable (m)
Cable (mm 2 )