Panasonic WVCU360C - SYSTEM CONTROLLER, Руководство по эксплуатации

Страница: 60 / 77

62
OPERATING PROCEDURES (For WJ-SX350)
This section describes only some important operations
such as login, logout, and different operations from the front
panel of the WJ-SX350.
Please refer to the manual included with the WJ-SX350 for
further information on camera selection, monitor selection
and so forth.
■
Login & Logout
●
Login
1. Type your registered operator number (a maximum of
15 digits) using the numeric buttons, then press the
CAM/SET button. If login has been successful, the
LOGIN indicator lights up. If it has failed, another
attempt can be made when the PROHIBITED indicator
goes off after 2 seconds.
2. Type your registered password (a maximum of 5 digits)
using the numeric buttons, then press the CAM/SET
button. If password entry has been successful, the
LOGIN indicator changes from blinking to steady light.
If it has failed, another attempt can be made when the
PROHIBITED indicator goes off after 2 seconds.
●
Logout
1. Type 00 using the numeric button, then press the
FUNCTION button. The LOGIN indicator turns off.
■
Lens Control (Auto Focus Operation)
The following function requires the use of a camera with
auto focus capability, such as the Panasonic WV-CS854.
1. Select the desired monitor and camera.
2. Press the FOCUS NEAR and FAR buttons simultane-
ously to automatically adjust the lens focus on the
selected camera.
■
Pan/Tilt Control (Camera Position
Operation)
The following function requires the use of a camera with
preset panning capability, such as the Panasonic WV-
CS854.
1. Select the desired monitor.
2. Select a registered camera position number using the
numeric buttons.
3. Press the ALT button (indicator light on), then press the
PRESET POSI button to activate the camera to move to
the preset position.
LOGIN
MON CAM
ESC SET
1 2 3
4 5 6
7 8
0
9
LOGIN
MON CAM
ESC SET
1 2 3
4 5 6
7 8
0
9
FUNCTION
AUTO FOCUS
NEAR FAR
FOCUS
ALT
CAM
POSI
PRESET
POSI