3. Tilt the camera in the direction of the Arrow
Mark until the protrusions on the camera fit
into the grooves in the upper portion of
the screw hole.
If the camera is difficult to tilt, slightly bend
open the bracket on both sides.
4. Tighten camera and bracket with the two
screws.
5. Detach the camera with the bracket from
the base plate by removing the two screws
to change the camera position.
6. Move the camera with the bracket to the
position on the base plate as shown in the
diagram and tighten it with the two screws.
Caution:
Confirm that the direction of the
camera shown in the diagram coin-
cides with the top of the image dis-
played on the monitor screen.
Tilt the camera until protrusions
of the camera fit into these
grooves in the screw hole.
This camera can pick up images through the
holes on both sides of the panel cover. This
requires moving the position of the camera.
To pick up images through the hole above, fol-
low the procedure shown below.
1. Detach the panel cover by rotating it coun-
terclockwise.
2. Remove the two screws holding the cam-
era shown in the diagram.
■
CHANGING OF CAMERA INSTALLATION POSITION
Arrow mark
Top of screen image
