20
■
Indicators and buttons
A
INITIAL SET button
Follow the steps below to initialize the network camera.
⑴
Turn off the power of the camera. Disconnect the Ethernet cable from the camera.
⑵
Turn on the power of the camera while pressing the INITIAL SET button, and make sure to
release the button after approximately 15 seconds.
In about 2 minutes later, the camera will
start up and the settings including the network settings will be initialized.
Retry if the camera
does not start up normally.
IMPORTANT:
When the camera is initialized, the settings including the network settings will be initialized.
Before initializing the settings, it is recommended to write down the settings in advance.
Do not turn off the power of the camera during the process of initialization. Otherwise, it may
fail to initialize and may cause malfunction.
A
INITIAL SET button
SD slot
D
ACT indicator
C
LINK indicator
B
SD ON/OFF button
F
SD MOUNT indicator
E
SD ERROR indicator
⑴
When the SD ON/OFF button is pressed (less than 1 second), the SD MOUNT indicator lights
up in green and data can be saved to the SD memory card.
⑵
When the SD ON/OFF button is held down (about 2 seconds), the SD MOUNT indicator lights
off and the SD memory card can be removed.
B
SD ON/OFF button
C
LINK indicator
D
ACT indicator
When the camera is able to communicate with
Lights orange
the connected device
When data is being sent via the network camera
Blinks green (accessing)
* Image of camera 1 is omitted for simple explanation.
