25
Note:
• When using a DHCP server, the IP address assigned to the camera can be displayed by click-
ing the [Search] button of the IP setting software.
• When a duplicate IP address is used, the corresponding camera number will be displayed
shaded.
• When the [Access Camera] button is clicked, live images of the selected camera will be dis-
played.
• It is possible to change the "Camera list" display between IPv4 addresses and IPv6 addresses
in accordance with the protocol in use.
• The information displayed can be sorted by clicking the title of each displayed item.
c
Complete each network setup item and click the [Save]
button.
Note:
• In the camera settings, "Auto IP" is deactivated even
when it is selected for the connection mode.
• In the camera settings, the "Primary DNS" and
"Secondary DNS" settings are deactivated.
IMPORTANT:
• It may take for about 2 minutes to complete to upload the settings to the camera after clicking
the [Save] button. The settings may be invalidated when the LAN cable is disconnected before
completing the upload. In this case, perform the settings again.
• When using a firewall (including software), allow access to all UDP ports.
• The Wearable Camera Agent Software and Panasonic IP setting software cannot be used on
the same PC at the same time. To use the Panasonic IP setting software on a PC with
Wearable Camera Agent Software installed: right click "My Computer" and select "Manage" to
open the "Computer Management" screen, select and right click "Wearable Camera Agent"
from [Services and Applications] - [Services], and then select "Stop". After finishing using the
Panasonic IP setting software, perform the above steps again, select and right click "Wearable
Camera Agent", and then select "Start".