![background image](http://html1.mh-extra.com/html/panasonic/wv-sw355pj/wv-sw355pj_installation-manual_4171224024.webp)
24
Heater Unit WV-SW3H (option)
• Installing this heater unit enables the camera to operate in a low-temperature environment of
–30 °C {–22 °F} or above. A small fan inside the unit will minimize condensation on the surface
of the enclosure caused by changes in ambient temperature unless temperatures change too
rapidly. The fan will stop when there is no possibility of condensation.
• The heater unit is automatically turned on or off according to the temperature inside the camera
that is monitored.
Important:
• Turning the heater on and off may disturb the camera images.
• The power supply of the camera shall be turned off when mounting or dismounting the heater.
When servicing, pay attention to high temperature on the surface of the heater unit. Disconnect
the harness and wait until the heater unit cools.
• When this product is installed and operated in low temperatures below –10 °C {14 °F}, normal
images may not be obtained immediately after startup. In such a case, wait until the camera is
warmed up (approx. 2 hours or more) and turn on the power again.
How to install the heater unit
q
Detach the camera’s enclosure (
☞
page 34) and mount it in the specified position with the
screw (accessory).
w
Connect the harness cable to the heater unit connector of the camera.
Important:
• After mounting the heater unit, arrange the harness cable as shown in the illustration in step
e
so as not to be tangled round the enclosure, assist wire or equipment inside the camera.
How to install the heater unit
Содержание WV-SW355PJ
Страница 50: ...50 ...